Z axes displayed
Posted by headviking
|
Z axes displayed May 15, 2019 02:14PM |
Registered: 6 years ago Posts: 9 |
Before I switched from my Anet A8 motherboard and display, I got information about my Z axes height during bed leveling. Now after installing my Ramps 1.4 with a smart display I do not get that information. Anyone know what I can do to get it back?
I'm still new to this 3D printing and configuring out Marlin firmware..
I'm still new to this 3D printing and configuring out Marlin firmware..
|
Re: Z axes displayed May 15, 2019 05:14PM |
Admin Registered: 12 years ago Posts: 3,096 |
What display do you have exactly? I can see it with both the LCD and the 12864-based graphic screen. So on those panels it should really be normal to see the Z-height in hundreds of MM's.
http://www.marinusdebeer.nl/
http://www.marinusdebeer.nl/
|
Re: Z axes displayed May 15, 2019 05:58PM |
Registered: 8 years ago Posts: 1,946 |
Where did you get the A8 Marlin firmware.
Here is a link to GitHub A8 Firmware.
Computer Programmer / Electronics Technician
Here is a link to GitHub A8 Firmware.
Computer Programmer / Electronics Technician
|
Re: Z axes displayed May 16, 2019 01:17AM |
Registered: 6 years ago Posts: 9 |
|
Re: Z axes displayed May 16, 2019 01:19AM |
Registered: 6 years ago Posts: 9 |
Not sure. It was a while ago.
Sorry, only registered users may post in this forum.