Welcome! Log In Create A New Profile


Initial tool change retraction for dual nozzle printers

Posted by Schild0r 
Initial tool change retraction for dual nozzle printers
July 30, 2019 02:07PM
Hey there again,

I am currently experimenting with my second nozzle which has been unused since I finished my setup.
I am using PrusaSlicer which has a setting to retract the inactive tool by a variable value.
Unfortunately it will only do so on the first tool change but not on the beginning of a print which will cause the unused nozzle to droop until the first tool change is done.

Has anyone found a workaround for this? I know that Slic3r / PrusaSlicer support conditions in the custom gcode section but I don't know how this might help me.

I am looking for a solution that works for either extruder (no matter whether the first one or the second one is inactive from the start)

Any help is much appreciated.
Sorry, only registered users may post in this forum.

Click here to login