recently upgraded my Ender 3 with a MKS GEN L V2 board and TMC2209 drivers, everything was working fine, but after changing my LCD screen to a one having sd card readerThis LCD and after re-flashing marlin 2.0 motors are were not moving at all, Even tough I try to auto home, I can move them freely with my hand. I suppose I messed up software because after many failed attempts I flashed This Marlin build, my motors started moving a little when auto home is pressed (wrong directions and after a little they would stop). Any suggestions? This is my Marlin Configurations




Thanks in advice

From the discord, where they also posted

you need to identify your controller
your github called MKS_GEN_L motherboard is set to BOARD_RAMPS_14_EFB not BOARD_MKS_GEN_L and the github you said moved a little is set to MKS_GEN_L_V2
so which do you actually have?
the reddit post say "Ender 3 with a MKS GEN L V2"
so you should have #define MOTHERBOARD BOARD_MKS_GEN_L_V2

in fact provided configuration in [github.com] is stock, not customized at all!

start with the config for an ender 3 with orrginal controller
and update motherboad to BOARD_MKS_GEN_L_V2
and go from there.
[github.com]

also make sure you disable CR10_STOCKDISPLAY and enable REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER so your dispaly works.

Edited 1 time(s). Last edit at 11/09/2020 07:37AM by Dust.