Hello, I'm new to the forum. I installed version 1.1.9 Marlin on a Creality cr-10. My problem is that when the machine finishes printing, the Y axis is positioned opposite to how it was positioned before.
Having already built a wooden enclosure, the Y axis directed in the front position hits the door.
If I send to Auto Home from the LCD display the direction has remained unchanged since before the update and therefore it goes to the back position, which would be the position that should also go at the end of the print. How can I change the direction of the Y axis in the firmware only for automatic positioning at the end of printing?
I thank everyone in advance. Samuel
Edited 1 time(s). Last edit at 11/17/2020 10:32AM by Samu90.
