I'm trying to check my extruder's steps/mm and I can't figure out how to bypass the cold extrusion prevention. Im using Marlin 2.0. I tried M302 as well. Says it's disabled but its not because it keeps giving me a warning and asking if I want to heat the hotend.
I tried commenting this out:
#define PREVENT_COLD_EXTRUSION
That didn't work.
I tried changing this to 0:
#define EXTRUDE_MINTEMP 180
That didn't work.
It keeps telling me that I'm trying to extrude below 180 despite what EXTRUDE_MINTEMP is set.
Help me out please. Thanks.
EDIT:
I tried commenting:
#define THERMAL_PROTECTION_HOTENDS
Doesn't work. Nothing works. Keeps telling me hot below min temp 180. What the hell.
Edited 3 time(s). Last edit at 07/11/2021 06:18PM by CVRIV.