Welcome! Log In Create A New Profile

Skienforge help, Huxley bowden fix, New hot tip

Posted by owism8

owism8

Re: Skienforge help, Huxley bowden fix, New hot tip
July 20, 2011 03:21PM

Registered: 13 years ago
Posts: 248

Yes that was copied from the wiki. So it should still work no matter what number is there?

Where is the End.gcode file located? Is it skeinforge or repsnapper?

Reply Quote

owism8

Re: Skienforge help, Huxley bowden fix, New hot tip
July 21, 2011 11:07AM

Registered: 13 years ago
Posts: 248

That made my Z go down too... How do I only get X and Y to move?

Reply Quote

rhmorrison

Re: Skienforge help, Huxley bowden fix, New hot tip
July 21, 2011 12:48PM

Registered: 14 years ago
Posts: 3,742

If sending the command:

G28 X0 Y0

Causes your Z-axis to move then you have a serious firmware/hardware problem.

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Reply Quote

owism8

Re: Skienforge help, Huxley bowden fix, New hot tip
July 21, 2011 05:32PM

Registered: 13 years ago
Posts: 248

Techzone firmware. What else can I upload to a monolithic board?

Reply Quote

Page 2 of 2 Pages:

Newer Topic Older Topic

Print View RSS

Sorry, only registered users may post in this forum.

Click here to login