Welcome! Log In Create A New Profile



Posted by Abs_dump 
October 14, 2021 02:34PM
Inherited a makerfarm 10" prusa i3v.

Apparently makerfarm is no more? Curious what happened? Can't find an archive that doesn't lead back to makerfarm.com which is no longer.

My printer needs a going through particularly to check wiring. Some wires are disconnected.

I'm looking for wiring diagrams, makerfarm original assembly instructions, calibration instructions, start-up & troubleshooting etc.

How generic is my printer regarding electronics, wiring and firmware?

Thanks in advance.
Re: Makerfarm
November 02, 2021 01:05PM
Assembly videos for Makerfarm i3 are available here: [www.youtube.com]

Thingiverse ID Alan1279
Re: Makerfarm
November 02, 2021 09:47PM
Many thanks for the link, This will help a
Re: Makerfarm
November 03, 2021 02:04AM
Probably got one of these in it;-


Totally generic if a bit quaint for the hardware. Don't know what firmware they supplied but Marlin 1.19 is adequate (current firmware).

There are LOADs of ways to tweak it.

Edited 1 time(s). Last edit at 11/03/2021 02:11AM by DragonFire.
Re: Makerfarm
November 03, 2021 08:22PM
Good to know!

Should I worry that the youtube vids might disappear like Makerfarm.com?
Re: Makerfarm
November 06, 2021 05:45PM
It can be erratic even with manufacturers that are still selling.

You should at least have more of an idea where the wires connect.
Sorry, only registered users may post in this forum.

Click here to login