Welcome!
Log In
Create A New Profile
Home
>
General
> Topic
Advanced
DIY non-stick coating for nozzles and hot ends
Posted by
deckingman
Forum List
Message List
New Topic
deckingman
DIY non-stick coating for nozzles and hot ends
January 31, 2022 05:53AM
Registered: 8 years ago
Posts: 622
I've just uploaded a short video about a spray which I have found to be remarkably good at preventing filaments from sticking to the outside of nozzles and hot ends.
Hope this might be useful to others [
youtu.be
]
[
somei3deas.wordpress.com
]
[
www.youtube.com
]
Reply
Quote
ravi
Re: DIY non-stick coating for nozzles and hot ends
February 14, 2022 06:40AM
Registered: 2 years ago
Posts: 2
I had this happening and turned out the brass nozzle was loosening from repeated heating cycles over time.
Clean it up and re-tighten everything(barely tighten when cold, then heat the hotend and finish snugging it up) and you should be golden.
Reply
Quote
obelisk79
Re: DIY non-stick coating for nozzles and hot ends
February 17, 2022 06:25AM
Registered: 7 years ago
Posts: 363
What does a loose brass nozzle have to do with non-stick coatings?
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login
