Hi Everybody,
I would like to know how to configure a new 4 Axis 3D printer to Ultimaker Cura and/or PrusaSlicer that use RepRap firmware and I have all .G codes if needed please.

I will be using Big Tree Tech Octopus Mother board, if that helps in any way.

Many thanks in advance

Siamak

@Siamak

4 axis slicing is not common place, it is not supported in Cura or Prusa slicer

In Cura or PrusaSlicer, set up your printer as a custom printer, adjusting the bed dimensions and using custom G-codes to drive axis 4.

_{Mini Militia App Lock}

Edited 1 time(s). Last edit at 02/10/2025 05:40PM by jodefoy.