Leapfrog Bolt Pro

Hello everyone.

This my first post on this forum, so I hope I have the right location.

Anyway, I have just obtained a faulty Leapfrog Bolt Pro, very cheaply, however it has been worked on and some parts are missing.
I'm still trying to figure out whats missing, and as Leapfrog have now closed, the amount of information online is pretty sparse.
So far I see its missing the following parts.
Raspberry Pi board.
The attached fan board.
The touch screen.
If anyone can please send and close up photos of the Raspberry Pi assembly, and let me know what the daughter board with the fan is, it would help immensely.
Additionally, if there is a wiring interconnection schematic anywhere, that would ease my work as well.
Lastly has anyone modified one of these machines using other controllers etc? This may be a route I need to go down.

Thanks in advance.
Bob .

I found this Leapfrog web site on my first search, 1st page opened.

It appears to have most of the information you should need.

[www.reddit.com]

[reprap.org]

Edited 2 time(s). Last edit at 06/08/2025 06:44PM by Roberts_Clif.

---

Computer Programmer / Electronics Technician

Good day

I am in a similar situation - have a Leapfrog Bolt Pro but not working and bcause of the company not supporting this machine anymore - unable to obtain parts to repair it. I was sondering if anyone has tried retrofitting / modding this machine to use new parts and software - I will have to replace the extruders, hotends and motherboard / software.

Is this a vialbe option / has anyone tried this / nay advice

Thanks

There's a thread on conversion of a Leapfrog printer to new electronics at [forum.duet3d.com] although it may be a different model.

Edited 1 time(s). Last edit at 07/21/2025 01:50AM by dc42.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].