Welcome! Log In Create A New Profile


hot end

Posted by morrist 
hot end
July 29, 2011 10:38PM
so im looking to replace my hot end, my techzone one is full fail. im thinking about this one. im in the states, so this one lo0oks like what i may do.
any thoughts or comments?

Re: hot end
July 30, 2011 12:08AM
Makergear make excellent hot ends, and have excellent support. They're well liked by the reprap community. Rick (the owner) hangs out in reprap irc and his own channel, #MakerGearV2 under the nickname 'MakerGear|Rick' if you have any specific questions

Wooden Mendel
Teacup Firmware
Re: hot end
July 30, 2011 12:35AM
thanks, looks like il order the pack for the wade extruder style tomorrow
Re: hot end
July 30, 2011 12:35AM
I would recommend them 100%. I've purchased two hot ends from them, one of which I've put 5 pounds of PLA through without a single jam.

Help improve the RepRap wiki!
Just click "Edit" in the top-right corner of the page and start typing.
Anyone can edit the wiki!
Sorry, only registered users may post in this forum.

Click here to login