Welcome! Log In Create A New Profile

Tolerance of parts produced by Mendel etc. RepRaps

GreenAtol

Tolerance of parts produced by Mendel etc. RepRaps
August 08, 2011 03:49PM

Registered: 12 years ago
Posts: 48

I know it will vary greatly depending on material etc. but what are some examples of the sort of tolerance these Official RepRap printers are getting? Ideally this info should be displayed somewhere since it is a fundamental performance parameter.....

Reply Quote

jim_blag

Re: Tolerance of parts produced by Mendel etc. RepRaps
August 08, 2011 03:53PM

Registered: 13 years ago
Posts: 113

It's on the overview page for the Mendel here

JB

--
Check out my blog: AdventuresIn3-DPrinting

Reply Quote

GreenAtol

Re: Tolerance of parts produced by Mendel etc. RepRaps
August 08, 2011 07:51PM

Registered: 12 years ago
Posts: 48

Oh. Oops, thanks. I had searched the wiki with various keywords and it didn't turn up. Maybe using industry standard terms would help.

Reply Quote

Pointedstick

Re: Tolerance of parts produced by Mendel etc. RepRaps
August 14, 2011 08:34AM

Quote
GreenAtol
Oh. Oops, thanks. I had searched the wiki with various keywords and it didn't turn up. Maybe using industry standard terms would help.

It's a wiki; go ahead and fix it! winking smiley