Mendel Building Project in Finland
Posted by Ruyzen
|
Re: Mendel Building Project in Finland October 17, 2011 11:11AM |
One Mendel (original, not Prusa) "ready" in Oulu.
Needs looots of adjustement, though. 30mm x 30mm solid square looks more like 33 mm x 35 mm fishing net
Firmware adjustments, here I come...
Gen6 electronics, Prusa type hot end (~13 mm shorter) so OpenX carrier was needed and lots of shortening for Z-opto thin sheet.
But it prints
.
Needs looots of adjustement, though. 30mm x 30mm solid square looks more like 33 mm x 35 mm fishing net
Firmware adjustments, here I come...Gen6 electronics, Prusa type hot end (~13 mm shorter) so OpenX carrier was needed and lots of shortening for Z-opto thin sheet.
But it prints
.
Sorry, only registered users may post in this forum.