gcode custom

Quote
Strofe
Bonsoir

Intéressant comme idée...

M42 - Change pin status via gcode

The syntax for the M42 command is: M42 S(value to be written to pin) P (pin number) e.g. To set digital pin 30 high, you would use M42 S1 P30

Mettre à 1 (niveau haut) la pin 30 --> M42 S1 P30

The MARLIN firmware will not enable you to change the status / write values to any of the pins in use for things such as the heaters, thermistors, end stops etc. The command will let you send values other than 0 and 1 to any pins which can output analogue values. (0-255)

[forums.reprap.org]

Sous SLic3R tu peux intégrer du GCode sous --> PrintSetings --> Custom Gcode (Start, End, changement de couche, changement d'outil)...

[attachment 34591 Slic3R.JPG]

Pour aller plus loin le post processing : [forums.reprap.org]

A tester... Tiens nous au courant stp.

A+