What does the flow-rate ruler do ?
October 23, 2014 05:17AM
In my Repetier host, I have a few rulers
At start they are at 100

flow rate is one of them

what happens when I increase or decrease that value during print ?
I mean.. is it separate from other speeds ? Just more plastic in the same time ?

And what I fI increase only the displacement speed ?
No influence on the plastic flow , or will things increase in relevant order with other speeds ?

p.s. I come from Pronterface, where those values were fixed


Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)
Re: What does the flow-rate ruler do ?
November 08, 2017 04:40AM
If you increase the "flow rate" you increase the amount of filament extruded, decrease then decrease the filament.
Sorry, only registered users may post in this forum.

Click here to login