My Prusa i3 print jobs are printing OK. However, at the end of every job, the extruder seems to run fast in the Y axis and hits the end stop really hard and grinds the stepper for a couple of seconds.
I was wondering if the Gcode was moving the head too fast at the end of the job?
So I looked at the code and see this at the end:
G1 X111.890 Y75.600 F5400.000
G1 X111.890 Y34.617 E18.62386 F1200.000
G1 F4320
G1 X111.890 Y47.217 E11.97386
G1 E11.62386 F2400.00000
G92 E0
M107
M104 S0 ; turn off temperature
G28 X0 ; home X axis
M84 ; disable motors
Could it be the F4320 feed rate is setting it too fast? How can I change this for all my jobs?
Thanks...