where to get parts.... for spreadsheet use

Hi there,
I am requesting any parts suppliers contributions
from those kind enough to share, Eventual aim is to add
an aus section to the spreadsheet on the wiki.

Main focus is some of the more hard to find stuff
as most of us even in regional areas should be able
to find nuts, threaded rod etc.

Just reply below or PM.

thankyou.

There are lots of differing electronic systems that can be used for Repraps. IE Arduino or Makerbot etc.
All the electronics I'm using for my CNC/Repstrap are from Oatley Electronics in QLD.

Oatley's CNC Page here:

[secure.oatleyelectronics.com]

Here is a PDF of all the wiring and Boards:

[secure.oatleyelectronics.com]

They have kits for the PC Interface, Power Supplies, Driver boards for 4 wire and 6/8 wire stepper motors.

The PC interface board also has two on-board relays (extruder on/off - Fan on/off) a fourth Axis Stepper controller if needed and two sets of I/O lines which can be used for end positioning or home position switching etc.

Oscar Fox.

Edited 1 time(s). Last edit at 01/14/2010 12:27AM by Oscar Fox.