Welcome! Log In Create A New Profile


Firmware install and setup on MKS GEN V1.4

Posted by ant0ny 
Firmware install and setup on MKS GEN V1.4
November 28, 2016 06:24PM
This is a paying customer in Altona North in Melbourne.

The guy has contacted me in Brisbane for help on this.

Partial Quote: Hi I'm just enquiring as to whether you can set up firmware for my upgraded 3D printer... GEN 1 Reprap Prusa Mendel upgraded M/B to a MKS GEN V1.4 ... My main issue now is configuring firmware to get it operational with a heatbed and LCD/SD card interface.

I have not quoted or set a rate for this job. Contact me with some details of you contact and I will pass it on.

Sorry, only registered users may post in this forum.

Click here to login