Welcome! Log In Create A New Profile

Need stepper controller

Posted by Chip936

Chip936

Need stepper controller
May 14, 2011 08:36AM

Registered: 13 years ago
Posts: 1

Hi all,

In putting together by TechZone Mendel, I finally got all the electronics working and then my Z axis stepper controller went boom before I could start printing.

Does anybody in Melbourne have an extra stepper controller for Gen 3 electronics?

[tepperControllerWiring.jpg" target="_blank" rel="nofollow">www.reprap.org]

Thanks in advance
Chip

Reply Quote

noonan

Re: Need stepper controller
May 16, 2011 06:09PM

Registered: 13 years ago
Posts: 26

emailed you this morning... if I can get my RAMPS setup working then I will have some Techzone bits to sell off.