Hey Reprappers
I am in need of some help, I am working on a Mendel and it is begins to be a very long project.
The problem is with the “Extruder controller v2.2” board, when I try to program the chip, I get an error.
I am using these tools:
Main Chip: ATMEGA168 20AU
Uploading tool: USBtiny
Uploading program: Arduino v18
Bootloader: ATmegaBOOT_168_diecimila.hex
I am getting this error:
avrdude: verification error, first mismatch at byte 0x39aa
0x85 != 0x00
avrdude: verification error; content mismatch
Is there any one there know what this means and what a solution might be.
could really use some help.
greetings from
SirBj