Created a complete Basic setup of Smoothieware on Sbase 1.2
Posted by dintid
|
Created a complete Basic setup of Smoothieware on Sbase 1.2 April 20, 2016 12:37AM |
I'm a bit unsure if I should post here or not, but let me know if I erred 
While setting up my new MKS Sbase 1.2 and getting to know Smoothieware I wrote an Instructables.
[www.instructables.com]
Edits: inserted image and url.
Edit: changed subject to more accurately match the content of this post.
Edited 3 time(s). Last edit at 04/21/2016 05:32AM by dintid.
My Instructables - both total newbie instructables and some for intermediate users.
My Designs on Thingiverse
YouTube channel containing a few 3D printing videos - they are videos for my Instructables, and mostly not standalone.
Ultius / Tantillus Thingiverse Group
While setting up my new MKS Sbase 1.2 and getting to know Smoothieware I wrote an Instructables.
[www.instructables.com]
Quote
dintid on instructables
This Instructables is about finding our way around and Configuring the MKS Sbase 1.2 32-bit controller Card basics and intro to Smoothieware. I guess it can be used for Smoothieboards as well to some extent.
I am going to explain and set it up to work as a new controller in my Ultimaker 2 clone with a single extruder.
Edits: inserted image and url.
Edit: changed subject to more accurately match the content of this post.
Edited 3 time(s). Last edit at 04/21/2016 05:32AM by dintid.
My Instructables - both total newbie instructables and some for intermediate users.
My Designs on Thingiverse
YouTube channel containing a few 3D printing videos - they are videos for my Instructables, and mostly not standalone.
Ultius / Tantillus Thingiverse Group
Sorry, only registered users may post in this forum.