Smoothieboard laser AND 3dprinter ?

Hi, i move from 8bit (ramps) to 32 (smoothieboard) i always used Repetier as firmware and setup my printer with laser AND 3dprinter.

So my questions are :

1) is possible to port/use a Repetier firmware into a smoothieboard ?
2) is possible configure smoothie firmware like repetier (3d printer settings + laser settings and choose form th emenu wich one to use) ?

My smoothie come yesterday so... i'm a smoothie-noob

---

Gigio2k - [Pescara] - RepTrash -=Delta G2K=-
| My Thingverse stuff | Vi aspettiamo su Stampanti 3D Italia su Facebook |

1) hell no. the idea is to get away from archaic bad firmware
2) I would ask in the smoothie forum [forums.reprap.org]

1) an angel is just died for this blasphemy
2) Ok thanks

Note: repetier save my delta, was the only firmware (well writed) that can handle my specs and setup

---

Gigio2k - [Pescara] - RepTrash -=Delta G2K=-
| My Thingverse stuff | Vi aspettiamo su Stampanti 3D Italia su Facebook |