Have an MKS Gen 1.4 that was in the process of starting a print. The bed came up to speed and then the nozzle temperature. The printer started it's motion and then I received a MINTEMP error for the nozzle temperature.
I understand the meaning of the nozzle temperature error but both temperature sensors are not reporting any temperature.
When I short the pins on the MKS I get the overtemp errors so it appears that the board can sense shorted conditions.
I have replaced the sensors with known good ones and still can't get any readings.
Has anyone experienced this type of behavior? I am running Marlin 1.1.0 RC6 (I know it is a little older but I have been running it for years)
EDIT: Corrected terminology
Edited 1 time(s). Last edit at 01/26/2019 04:13PM by Nargousias.
