I bought an ender 3 a few days ago, and when i tried to calibrate the heatbed, the metal clamp fried one of the stepper drivers. Becuse i cant change it on the factory motherboard i had to buy a new one, so i bought the MKS GEN L motherboard. When i was trying to make it work, the motor just vibrated. I made a huge mistake and then put a drv8825 stepper driver in the board but backwards. That made the drv8825 smoke and spark. After that the motherboard does not connect to the pc.
Can anyone help to find out if my motherboard is fried?
Edited 1 time(s). Last edit at 05/29/2019 02:21PM by kriszmen66.