Re: Firmware to drive X-Y galvanometer January 21, 2019 01:50PM |
Registered: 5 years ago Posts: 10 |
Quote
VDX
... I'm actually finishing the development of a XY-laserscanner -- based on an old dentalscanner, which I've completely disarmed, and then 'refurbished' with the parts and drivers for the XY-galvoscanner, drivers and power sources.
Attached are some images of the device without enclosure (and an image of an original dentalscanner) and some testing results with a 445nm-diode.
This diode is not meant to be used with the galvos (in this distances the spot is a line, not a dot!), only for visualising while developing.
In the next days I'll arm it with a fiber-laser, so it should be usefull to mark/engrave much more than paper
And here a video of the part in 'action' - [vimeo.com]
Re: Firmware to drive X-Y galvanometer January 21, 2019 05:54PM |
Admin Registered: 16 years ago Posts: 13,886 |
Re: Firmware to drive X-Y galvanometer September 26, 2022 08:20PM |
Registered: 5 years ago Posts: 1 |