STM32 WorkStation Project

Hello dear developers, I want to tell you about my project. I've been working on it for a year.

This CNC controller based on STM32F10x LQFP64 chip. I have positioned it as a universal controller and not only for 3d print.
It not ready for 3d print yet, only for milling with limitations.

Main features:
Supporting four contact motor drivers as l293dne,l298,etc. Implemented
Supporting step/dir motor drivers as pololu. Not Implemented
STM32F10x chip family auto detecting. Tested.
SPI LCD dispaly Nokia 6100(phillips),Nokia 2650(Epson). Implemented
SD Card Support. Not Implemented
RS232 Interface. Implemented
USB interface. Not Implemented
RTC clock and calendar with battarey power. Implemented
RS232 flashing without programmer. Tested. Worked.
IR remote control. Implemented.
And other ideas...

I want to make this project as open source, but i want payment (donate).
How do you think you are. Maybe I'm wrong?

Edited 1 time(s). Last edit at 08/22/2013 01:31AM by Evgeniy.

I doubt your gonna get any donations from the reprap community to fund an unfinished project that isn't arduino based.
Maybe if you get it working You could find private investment and turn it into a proprietary product and sell units to reimburse your investors.....

---

=======================================================
A wise man once told me "Never trust a man who doesn't own a shed!"
=======================================================
Gen 6 daughter board
[forums.reprap.org]
Mendel PCB heatbed
[forums.reprap.org]
=======================================================

Thanks for the information slymike. Maybe I'll do my project is open to all, in 5-7 months.