Welcome! Log In Create A New Profile

Advanced

heated bed and extruder not heating up

Posted by Hallestman 
heated bed and extruder not heating up
August 24, 2013 09:25AM
my heated bed and extruder refuse to heat up anymore they used to but don't now. i have a 12 volt 17 amp power supply but it doesn't work. any suggestions?
Re: heated bed and extruder not heating up
September 05, 2013 07:57AM
Hallestman Wrote:
-------------------------------------------------------

> i have a 12
> volt 17 amp power supply but it doesn't work. any
> suggestions?


Does your PSU work? do you get a reading of 12v with a multimeter? do you hear fans (if applicable) when you turn it on?


=======================================================
A wise man once told me "Never trust a man who doesn't own a shed!"
=======================================================
Gen 6 daughter board
[forums.reprap.org]
Mendel PCB heatbed
[forums.reprap.org]
=======================================================
Sorry, only registered users may post in this forum.

Click here to login