Welcome! Log In Create A New Profile

Where to get stepper motors?

Posted by Matthew

Matthew

Where to get stepper motors?
December 17, 2009 02:35AM

Any ideas where to get stepper motors from? particularly Nema17 with enough holding torque. Preferably with good shipping to europe...

Reply Quote

VDX

Re: Where to get stepper motors?
December 17, 2009 05:20AM

Admin
Registered: 18 years ago
Posts: 14,162

... look at Nanotec ...

Viktor

Reply Quote

nophead

Re: Where to get stepper motors?
December 17, 2009 02:23PM

Admin
Registered: 18 years ago
Posts: 7,883

Cheaper here in the UK, don't know if they ship to Europe: [www.slidesandballscrews.com]

Edited 1 time(s). Last edit at 12/17/2009 02:24PM by nophead.

[www.hydraraptor.blogspot.com]

Reply Quote

Matthew

Re: Where to get stepper motors?
December 18, 2009 04:07AM

thanks guys smiling smiley

The nanotechs are a bit pricy...

The UK guys look good and they ship to Europe. Nice one nophead! Do you use their motors?

Reply Quote

nophead

Re: Where to get stepper motors?
December 18, 2009 05:06AM

Admin
Registered: 18 years ago
Posts: 7,883

I use an identical spec one from MotionControl in my extruder. The only difference is the Zapp ones have a dual shaft, shorter leads and are half the price.

I have ordered some for my Mendel.

[www.hydraraptor.blogspot.com]

Reply Quote

D2TNJ

Re: Where to get stepper motors?
December 18, 2009 09:32PM

Registered: 16 years ago
Posts: 5

First let me caveat this by saying I have not built my extruder yet. I'm still working on assembling the basic electronics.

But I did find these Lin Engineering steppers:

4218L-01-11

4218L-01D-02

Can anyone confirm/deny that these would work for an extruder?

Edit: Sorry, misread the initial post about shipping to Europe. It seems they will ship to different countries, but I have no knowledge of the shipping cost.

Edited 2 time(s). Last edit at 12/18/2009 09:37PM by D2TNJ.

Reply Quote

nophead

Re: Where to get stepper motors?
December 19, 2009 07:07AM

Admin
Registered: 18 years ago
Posts: 7,883

They look like they have enough torque. 0.5Nm at 2A compared to 0.4Nm at 1.7A for the one Adrian uses.