Hi,in these days im war with my 3d printer...
im download all file of official site Ultimaker,im make the mechanicall parts and all wire,sensor,head,motor and all..
after that long parts,im insert usb cable and start with Cura software for insert the firmware,but i have one bad sorprise...the firmware stopped when search the temperature sensor and not go up that part of installation of makine...result>>>>the 3d printer not work...
im write at seller of board and it write me if the board is not same at original board,the pin of he board aren't in same position....
im search the firmware but im not look nothing...
this is the link of my board(I have buy 2 same,for make 2 3dprinter)
[
www.ebay.it]
in first moment im think if the problem is the arduino not original,and buy one original,but the problem is same...
is possible for you help me to start this 3d printer ??
Very thanks for all ,best regards Huliofane
P.S. in these days im make a maps of all pin,for undestand how are connected all pin of arduino,this is a good idea or is not necessary ??
thanks