Welcome! Log In Create A New Profile

Will this power supply work?

caizprua46

Will this power supply work?
April 12, 2015 04:25PM

Registered: 11 years ago
Posts: 4

For my delta 3D printer I got this power supply [www.soaap.com] , but I'm wondering if a 3D printer can work with just 1 amp.

Reply Quote

laazarus

Re: Will this power supply work?
April 12, 2015 06:00PM

Registered: 11 years ago
Posts: 6

That would just about power the controller and nothing more. The extruder alone is going to pull about 6amp while it warms up.

Reply Quote

the_digital_dentist

Re: Will this power supply work?
April 12, 2015 09:08PM

Registered: 14 years ago
Posts: 5,801

You need to power four motors at about 1A each, the controller board- maybe about 1A, the bed heater (?)- about 10-20A depending on the machine, and the hot-end about 3-4A. That all adds up to 18-28A, mostly depending on the bed heater current.

A 1A supply isn't going to do the job.

Reply Quote

caizprua46

Re: Will this power supply work?
April 13, 2015 06:23PM

Registered: 11 years ago
Posts: 4

Actually I'm not using a heated bed (by a miscalculation on how much money I could spend on the 3d printer), but thanks!

Reply Quote

cdru

Re: Will this power supply work?
April 14, 2015 09:20AM

Registered: 12 years ago
Posts: 869

Quote
caizprua46
Actually I'm not using a heated bed (by a miscalculation on how much money I could spend on the 3d printer), but thanks!

Even if you don't have the money now, spending slightly more on a more powerful electronics could save you in the end if/when you do get a heated bed.