Welcome!
Log In
Create A New Profile
Home
>
Electronics Folder
>
Controllers
> Topic
Advanced
Multiple Heatbeds on one RAMPS 1.4 controller
Posted by
andybandy
Forum List
Message List
New Topic
andybandy
Multiple Heatbeds on one RAMPS 1.4 controller
June 11, 2015 07:07AM
Registered: 9 years ago
Posts: 8
Hey,
I'd like to use two heatbeds for a little project and connect them to a RAMPS 1.4 controller.
Could it cause any problems if I connect a heatbed instead of an extruder? (no extruder needed for that project)
Thanks!
Reply
Quote
andybandy
Re: Multiple Heatbeds on one RAMPS 1.4 controller
June 11, 2015 07:09AM
Registered: 9 years ago
Posts: 8
wrong Forum, please close
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login
