DUE3DOM and DUE3DOM MINI - 2 new shields for Arduino DUE

Hi Reprapers,

I would like to show my 2 new products, DUE3DOM and DUE3DOM MINI for Arduino DUE. DUE3DOM - due freedom

DUE3DOM
- motherboard for Arduino DUE
- 6 slots for stepsticks
- 2x AD597 onboard for K-type thermocouple
- LM2597 24-12V regulator up to 3A
- 4x thermistor headers
- 2x MOSFET up to 10A for hotends (fuse protected)
- 1x MOSFET up to 20A for hotbed (fuse protected)
- 3x fan headers (12V)
- fuse for electronic and stepper drivers
- 6x endstops headers
- EXP1 and EXP2 headers for typical LCD 128x64 like Reprap Discount Full Graphics Smart Controller
- ready for Marlin and Repetier firmware
- 12-24VDC power supply
- 24LC256 EEPROM onboard
- filtered stepper supply
- DIP-switches for microstep settings

DUE3DOM MINI
- shield for Arduino DUE
- 4 slots for stepsticks
- LM2597 24-12V regulator up to 3A
- 3x thermistor headers
- 1x onboard thermistor for PCB temperatur monitoring
- 1x MOSFET up to 10A for hotend (fuse protected)
- 1x MOSFET up to 20A for hotbed (fuse protected)
- fuse for electronic and stepper drivers
- 3x endstops headers
- EXP1 and EXP2 headers for typical LCD 128x64 like Reprap Discount Full Graphics Smart Controller
- ready for Marlin and Repetier firmware
- 12-24VDC power supply
- expansion, 25-pin header
- 3x fan headers (typical 2-wire fans)
- 1x 4-pin fan header or servo
- 24LC256 EEPROM onboard
- filtered stepper supply

These electronics developed with great support our RepRap comunity (peoples from our technical board called Fabrykator --> [www.fabrykator.pl]).
At now we are working on firmwares. Marlin work on both electronics (only have problem with AD597 on DUE3DOM). Repetier soon will be finished - Miś [our member] work on it, and one board I will ship Monday to Roland.

DUE3DOM mini + 128x64 LCD under Marlin
[www.youtube.com]

Edited 8 time(s). Last edit at 06/16/2016 12:15PM by codec.

---

_____________________________________________________
[www.facebook.com]

128x64 LCD with DUE3DOM MINI under Repetier firmware

---

_____________________________________________________
[www.facebook.com]

Hi

This looks good. I have a few questions

1. Is the firmware actually operational ? (by that i mean can is run a 3d printer good enough to print)

2. When will the boards be available ?

3. How much ?

4. Shipped from china or the EU ? (PLEASE PLEASE dont ship from china, I am so bored with waiting three months for parts to arrive )

Kindest Regards

Edited 1 time(s). Last edit at 06/29/2016 11:21AM by Calvinx66.

Hi looks like they are nice boards - where to buy them ? I did not found any shop selling them and I want to give a try

Thanks

Is it possible to buy yet? Which version of marlin did you port and are you going to keep it updated?

Today I was publish source files on Thingiverse. This is a MINI version. Soon I will put large, 6-driver DUE3DOM too.

[www.thingiverse.com]

Add file on Github
[github.com]

Today publish rev.2 on Github.