hello everyone

i'm totally new to electronics and i need some help

can i use "PM55L-048" motors in RepRap

if yes which type of driver i should use

The PM55L-048 Data Sheet shows 24V, and 7.5° step and ~0.1 N m

You really want 13.7 N-cm (0.137 N m) to have enough torque but they might do.

The 7.5° step is more of a problem, most use 1.8° step motors so your positional accuracy will be 1/4 of what most people are using. You will need to supply at least 24-30 volts to the stepper motors.

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

ok thank you for your reply

Regards