I had my RRD 20x4 LCD running on my Rumba board with marlinRC8. I was able to home the printer, make it move etc...
Then I plugged my RasPi3 with Octoprint installed and the LCD turned white at the next start. Resetting Rumba didn't change that.
OctoPrint only runs without LCD attached? Why?
Is it because I defined ultralcd
and reprapdiscount smart LCD? Why did it work without RasPi connected then?
Edited 1 time(s). Last edit at 02/26/2017 10:02AM by o_lampe.
