BL Touch and BIQU MKS-BASE V1.5 Plate Controller Board

Greetings!

I just purchased a new BIQU MKS-BASE V1.5 Plate Controller Board for 3D Printer Ramps 1.4 for my Folger Tech Kossel 3d printer. Looks like a cool board and I hope it performs well when I turn it on. The wiring is pretty straight forward and I feel I can connect everything except a BLTouch auto bed leveling probe.However, there is one problem I have run into so far. (Of course, it always has to the be problem that puts your project on hold) There is NO directions on where to wire the BLTouch probe (5 wires in all) to the MKS-BASE v1.5 board. I see directions for earlier boards, but could not get the earlier board through Amazon.

Does anybody here have a MKS Base v1.5 board and successfully connected a BLTouch(or any other sensor) to this board? BTW, I am putting glass over the aluminum plate. I may manually level the bed, but would strongly prefer to do this via auto-bed leveling approach.

Thanks again.

Edited 1 time(s). Last edit at 06/27/2017 11:59AM by panadar.

D11 is what you are looking for... as written on the BLTOUCH Homepage

Edited 1 time(s). Last edit at 06/28/2017 05:15AM by Kruemel33.