MKS TFT35 and MKS PWC

Hello. On sellers page [ru.aliexpress.com]

I have found instrution - PB4 - is auto power off, and PB0 - is power detection. I have connected, how it written. When ON button pressed - printer works. When I press button agait to make printer OFF - printer was ON still, without any reaction. It not catching POWER LOSS signal.

I tried to change connection - if I connect PB4 to VCC - I see on display "closing machine". But on PB0 - still +5v. AND MKS PWC not take off power. I think than some ouptup pin on MKS TFT32 must go to logic "0" after power loss and appearing "closing machine" after POWER LOSS ?

Anybody have MKS TFT35 and MKS PWC?

running latest v1.0.1 firmware ? [github.com]

Edited 1 time(s). Last edit at 07/02/2018 11:34AM by Dust.

yes, 1.0.1

Tell me - instruction data (PB4 - POWER OFF, PB0- POWER DETECTION) - is it correct? If correct - why if I connect PB4 to VCC, display try to off (appears "closing machine"). PB4 - is input or output?

my config

Anybody knows?

Hi,

Could you find the answer? I am also having the same issue.