pinout needed for Lerdge Hot Bed Expansion Interface Adapter Module
Posted by thequestor
|
pinout needed for Lerdge Hot Bed Expansion Interface Adapter Module July 04, 2018 01:01PM |
Can someone please give me the pinout for the 4 leads on this adapter?
There are 4 leads, but I only need the 2 for the signal. But I would like to know what each pin is for such as
VCC/SIG/GND/GND or whatever it is.
Thanks
|
Re: pinout needed for Lerdge Hot Bed Expansion Interface Adapter Module July 04, 2018 01:56PM |
looking further there is a fan header on this part
so now I am wondering if there are 2 for fan control and 2 for sensor readings so maybe F+/F=/S0/S1 ??
so now I am wondering if there are 2 for fan control and 2 for sensor readings so maybe F+/F=/S0/S1 ??
Sorry, only registered users may post in this forum.