PandaPi - Raspberry Pi as a motherboard for 3D printer
Posted by Dev00
|
PandaPi - Raspberry Pi as a motherboard for 3D printer January 11, 2020 06:14AM |
Recently I found on GitHub - PandaPi (https://github.com/markniu/PandaPi) project. A Raspberry Pi HAT board that turns a Raspberry Pi as a motherboard for 3D printer.
Kind of interesting, because it seems to use a Marlin version for Linux and directly generate step motor pulses and control signals by using WiringPi library.
Wondered if someone tested this board ?
Kind of interesting, because it seems to use a Marlin version for Linux and directly generate step motor pulses and control signals by using WiringPi library.
Wondered if someone tested this board ?
|
Re: PandaPi - Raspberry Pi as a motherboard for 3D printer April 28, 2020 03:35PM |
Ok!
You got my interest thoug I was looking and can not find a source for this Shield.
Computer Programmer / Electronics Technician
You got my interest thoug I was looking and can not find a source for this Shield.
Computer Programmer / Electronics Technician
|
Re: PandaPi - Raspberry Pi as a motherboard for 3D printer June 07, 2020 12:07PM |
Seguo con molto ... molto interesse
Sorry, only registered users may post in this forum.