Hello All,
I’ve tried searching the forums and endless googling and I’m still stuck, so I’ve resorted to this for help.
In short - I don’t know how to add software (slicer) controlled part cooling fans on my MKS SBASE 1.3 board running Marlin 2.0.5.2.
I’ve a homemade delta with dual part cooling fans on the end effector. I have my fans connected to P2_06 E1 Heater and also FAN_AUTO_ON set to HEATER_PIN_1 (P2_06) in Config_adv.h in marlin.
The problem is that the fans come on full when hotend is 50°> and can’t be controlled through pronterface or the screen (MKS TFT32)
Surely there is a way to control these fans so that I can leave them off for the first few layers and then bring them on? Or reduce them to 30-40% when printing ABS?
What am I doing wrong??
Edit - title changed to 'FIXED'
Edited 1 time(s). Last edit at 03/30/2020 05:18AM by Mils24.