Welcome!
Log In
Create A New Profile
Home
>
Electronics Folder
>
Controllers
> Topic
Advanced
MKS Gen l V1.0 pinout question
Posted by
MikeCL
Forum List
Message List
New Topic
MikeCL
MKS Gen l V1.0 pinout question
August 11, 2021 05:33PM
Registered: 5 years ago
Posts: 45
I'm trying to setup my filament runout sensor and I have it setup in marlin but I dont see where it says what servo pin I should be using?
Reply
Quote
Roberts_Clif
Re: MKS Gen l V1.0 pinout question
August 11, 2021 09:11PM
Registered: 6 years ago
Posts: 1,863
Configuration.h
//#define Z_PROBE_SERVO_NR 0 // Defaults to SERVO 0 connector.
And in Pins_?????.h file for your controller is the servo Pin #
Computer Programmer / Electronics Technician
Reply
Quote
MikeCL
Re: MKS Gen l V1.0 pinout question
August 11, 2021 10:44PM
Registered: 5 years ago
Posts: 45
yeah the config file I had did not have the pins.h file but I assume I saw one in the dir so I moved it over to where the others show and it's in the tab now
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login