Welcome! Log In Create A New Profile

Delta Router + 4th Axis

Posted by A2

Forum List Message List New Topic

Delta Router + 4th Axis
May 02, 2014 10:25AM

Registered: 10 years ago
Posts: 1,381

deltarouter.jpg

[www.buildlog.net]

[www.youtube.com]

Reply Quote

zacbot

Re: Delta Router + 4th Axis
May 09, 2014 12:15PM

Registered: 11 years ago
Posts: 142

I am also working on that...

Since this morning I fighting against Repetier Host. It does not want to go below Z = 0

I have tried everything, also did what is described here [www.open-electronics.org]

I am using latest version of both Repetier Host and firmware.

Reply Quote

Muscles

Re: Delta Router + 4th Axis
May 23, 2017 02:42AM

Registered: 9 years ago
Posts: 21

The problem it's repetier firmware, you need to change some options in order to go below z = 0, it's a security, because of course in a 3D printer you are not going to go below z = 0

Reply Quote

o_lampe

Re: Delta Router + 4th Axis
May 23, 2017 03:11AM

Registered: 8 years ago
Posts: 5,232

Did you see the thread is 3 years old?
I guess, they've figured it out by now winking smiley

OTOH, nice design. I wonder how useful it turned out to be?

Reply Quote

o_lampe

Re: Delta Router + 4th Axis
May 23, 2017 07:12AM

Registered: 8 years ago
Posts: 5,232

Just saw a few vids about hexagon LinuxCNC routers.

dc42, if you read this, can it be done with a Duet-board too? Each rod is a separate stepper.