Hello Everyone.
I recently purchased a prusa i3 from Lankeda China.
I have assembled it and tried the following where I am stuck.
Any help or advice will be appreciated.
1. The x y and z axis do not home properly.
2. When i press the home key of any axis the printer keeps trying to go beyond the end stops.
3. When I try to give manual increments it the movement per axes is limited to 150mm
4. I tried using marlin and updated the mother board but it won't respond and I faced the following error
avrdude: stk500_getsync(): not in sync: resp=9x0c
Request you to please help me with the printer.
Edited 1 time(s). Last edit at 11/19/2014 02:27AM by ajeybahekar.