VirtuCube 3D-Scanner
Posted by virtumake
|
VirtuCube 3D-Scanner February 22, 2013 03:51PM |
Hi, I just released the prototype of the VirtuCube 3D-Scanner.
It is a David-Scanner with an Acer K11, a Logitech C615 and an Arduino Turntable.
The whole setup is fixed relative to each other, so you just have to calibrate the scanner once. The whole thing fits into a box for maximum convenience
[www.youtube.com]
[www.thingiverse.com]
Best,
Bernhard
It is a David-Scanner with an Acer K11, a Logitech C615 and an Arduino Turntable.
The whole setup is fixed relative to each other, so you just have to calibrate the scanner once. The whole thing fits into a box for maximum convenience
[www.youtube.com]
[www.thingiverse.com]
Best,
Bernhard
|
Re: VirtuCube 3D-Scanner February 26, 2013 03:09PM |
I just tested the new Beta of David-Laserscanner 3.7 64 bit with the VirtuCube and got this scan without any post-processing in an additional software
David Beta: [www.david-laserscanner.com]
Donkey: [www.thingiverse.com]
David Beta: [www.david-laserscanner.com]
Donkey: [www.thingiverse.com]
Sorry, only registered users may post in this forum.