Where are the jig length measurements?

I'm building a Mendel but I can't seem to find the measurements for the jig lengths mentioned in the assembly data sheet. When I look at the data sheet, it tells me to look in the notes tab to find them. But when I look there, it mentions them. But I can't find even one single measurement length within the text located in the notes tab. The only measurements I can find are M1, M2 M3 and M4. Could someone please post these measurements or point me in the right direction to find this information.?

Thanks
eighty5max

IIRC it is with the rest of the bar / studding lengths as they made from studding.

---

[www.hydraraptor.blogspot.com]

In the Mendel assembly data sheet:



What is not to understand?

J1 = 290 mm
J2 = 234 mm
J3 = 157 mm

---

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Hey thanks guys. The cliche "If it was a snake, it would have bit me" applies here. I guess when I saw "Bar & Jig lengths (Read Notes Tab)", I thought it meant the measurements could be found in the actual notes.

Many thanks for the info
eighty5max