X, Y, and Z axis. Error: printer halted. kill (Make noise)

Hello, a few days ago I had assembled 3d printer. After installing Marlin firmware, I had opened pronterface and tried to move X,Y or Z axis but it make noise and doesn't move. I had not install heated bed yet but hotend is working fine. When I click X,Y or Z homing it gives an [ERROR] Errorrinter halted. kill() called!. All the endstop is opened but not triggered. Copy of the firmware is also attached. I hope my problem get resolved.

Do you have the type of stepper configured correctly
#define X_DRIVER_TYPE A4988
#define Y_DRIVER_TYPE A4988
#define Z_DRIVER_TYPE A4988
//#define X2_DRIVER_TYPE A4988
//#define Y2_DRIVER_TYPE A4988
//#define Z2_DRIVER_TYPE A4988
#define E0_DRIVER_TYPE A4988
//#define E1_DRIVER_TYPE A4988
//#define E2_DRIVER_TYPE A4988
//#define E3_DRIVER_TYPE A4988
//#define E4_DRIVER_TYPE A4988

When using
#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN
Include line below as you are not deploying a Probe.
#define FIX_MOUNTED_PROBE

You have almost the same setting that are use in my 3DP11/12 what 3D Printer is this for.

Edited 1 time(s). Last edit at 12/26/2018 09:01PM by Roberts_Clif.

---

Computer Programmer / Electronics Technician

Thanks for your reply. I had define stepper configured and also #define FIX_MOUNTED_PROBE but the problem remain the same. The noise is coming but X, Y and X axis are not moving. This 3d printer is Prusa i3 (RepRap).

Make sure you have inserted the 3 jumper links under each stepper driver PCB.

Edited 4 time(s). Last edit at 12/27/2018 09:56PM by Roberts_Clif.

---

Computer Programmer / Electronics Technician

Thanks a lot. I had forget Jumper to put. Now X, Y, and Z axis are working fine but now the Extruder stepper motor is not responding. I had check the stepper motor by pluging into x axis place, It works but when I put x-axis stepper motor in the place of extruder on ramp 1.4 it doesn't works. I had also tested the stepper driver but that is also fine. In extruder I had also plug in jumpers so that not the problem. So If anyone can help me out.

The Extruder will not operate unless the Nozzle temperature is up to 170C minimum.
This is a software protection feature to prevent cold extrusion, that could cause damage to your 3D Printer.

However you can disable this with M302 S0 ; always allow extrusion (disable checking)

Edited 2 time(s). Last edit at 12/28/2018 08:59AM by Roberts_Clif.

---

Computer Programmer / Electronics Technician

Sorry for the late reply. Thanks the problem got resolved.