Sockets ZMA and ZMB are both controlled from the 1 z stepper driver. This requires no special firmware settings. This works fine for a lot of cases.
Sockets YM and E1M have their own stepper driver, so this requires firmware to work.
Presuming Marlin firmware.
In Configuration_adv.h you will find the setting Y_DUAL_STEPPER_DRIVERS, enable this
If you have EXTRUDERS 1 in your Configuration.h it will automatically use the unallocated E1 stepper driver for Y2
Make sure to set Y2_DRIVER_TYPE and not E1_DRIVER_TYPE in Configuration.h
Edited 1 time(s). Last edit at 07/01/2020 04:09AM by Dust.