Welcome! Log In Create A New Profile

Dual Wire Gantry ?

Posted by aamcle

Forum List Message List New Topic

aamcle

Dual Wire Gantry ?
December 20, 2022 03:17AM

Registered: 4 years ago
Posts: 142

I'm interested in the Dual Wire gantry shown :-

240px-DW-G_X-axis.jpg

There would need to be simple modifications so the belt isn't twisted other than that it seems good.

Simply does it work and is it any good? The printer would have a 200x200mm build plate.

Atb. Aamcle

[reprap.org])

Edited 3 time(s). Last edit at 12/20/2022 03:42AM by aamcle.

Reply Quote

the_digital_dentist

Re: Dual Wire Gantry ?
December 20, 2022 09:03AM

Registered: 10 years ago
Posts: 5,747

How is it driven?

Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]

Reply Quote

aamcle

Re: Dual Wire Gantry ?
December 20, 2022 01:13PM

Registered: 4 years ago
Posts: 142

There is one stepper at the back.

I think I have worked out the problem there are a lot of wheels, direction changes and the belt is long.

I don't think it's in that respect its worse than CoreXY motion but it's only moving the printhead.

Atb. Aamcle

Reply Quote

the_digital_dentist

Re: Dual Wire Gantry ?
December 20, 2022 03:27PM

Registered: 10 years ago
Posts: 5,747

I don't think you're going to get XY positioning with a single motor.

Edited 1 time(s). Last edit at 12/20/2022 03:28PM by the_digital_dentist.

Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]

Reply Quote

aamcle

Re: Dual Wire Gantry ?
December 20, 2022 04:16PM

Registered: 4 years ago
Posts: 142

No the Y motion is not done with those belts, you still need a conventional set of Y axis rods and belts to move the printhead +- in Y.

The problem is that the diagram is minimal at best, I have tried to link to the wiki page but with out much success. I'll try again

better diagram and discussion