Cooling question about Gen7 v1.2 Board
Posted by danx3
|
Cooling question about Gen7 v1.2 Board October 12, 2011 03:40PM |
Hi, I have a V1.2 Gen7 board on my mendel prusa except cooling.
In the PIN.H fiveD gcode interpreter file, i see a fan is attach to pin 31:
In the RepRap Host program when active "cooling Fan" of my extruder zero, i see an GCode M106 sent to prusa but no fan at all.
The vent is tested and work fine.
Does anyone know how to active the fan? is a pin.h problem?
TIA
Edited 1 time(s). Last edit at 10/12/2011 03:43PM by danx3.
-------------------------------------------------------
Mendel Prusa with Gen7 v1.2 PCB , Wade's extruder 0.7mm. Custom Heated bed.
"BIG" Mendel Pusa with modified Gen7 V1.3 PCB , Wade's extruder 0.5mm with modified hotend (about 500x600x450mm printable area) <--- under construction
Plastics: Black PLA, Soft PLA, White ABS
Software: Skeinforge 4 for STL to GCODE, RepRap Host for print GCODE. Blender for STL designs.
In the PIN.H fiveD gcode interpreter file, i see a fan is attach to pin 31:
#define EXTRUDER_0_FAN_PIN (byte)31Pin31 I think means "Digital 31" or really pin40 on ATMEGA as i see in dedicated gen7 v1.2 picture:
In the RepRap Host program when active "cooling Fan" of my extruder zero, i see an GCode M106 sent to prusa but no fan at all.
The vent is tested and work fine.
Does anyone know how to active the fan? is a pin.h problem?
TIA
Edited 1 time(s). Last edit at 10/12/2011 03:43PM by danx3.
-------------------------------------------------------
Mendel Prusa with Gen7 v1.2 PCB , Wade's extruder 0.7mm. Custom Heated bed.
"BIG" Mendel Pusa with modified Gen7 V1.3 PCB , Wade's extruder 0.5mm with modified hotend (about 500x600x450mm printable area) <--- under construction
Plastics: Black PLA, Soft PLA, White ABS
Software: Skeinforge 4 for STL to GCODE, RepRap Host for print GCODE. Blender for STL designs.
Sorry, only registered users may post in this forum.