Am I missing something in the sprinter firmware?
In
configuration.h where you set the Calibration variables,
I have to enter 1/2 the expected values for a Metric Prussa Mendel, to make my machine behave.
The board is set for Sanguinololu 1.2 and above = 62
I have all three jumpers M1,2,3 set for 1/16 stepping (1.8 degree steppers)
If I have values of 80 for X & Y the machine travels 200mm for a 100mm demand.
Settings of 40 and it behaves.
I'm wondering if there is something I am missing in the firmware setup?
Or have I been sold 3.6 degree steppers?
Regards
Q
Edited 1 time(s). Last edit at 11/25/2011 12:18AM by QFE24.