Welcome! Log In Create A New Profile


Help compiling Marlin 1.0

Posted by CSN 
Help compiling Marlin 1.0
March 29, 2012 08:39AM
Am new to reprap.
Have built a Makergear Prusa with three microswitches as endstops from their kit with a fully constructed UltiMachine RAMPS 1.4 Using Arduino .22 to compile. Compiles fine, but I imagine I need to modify the source code in some fashion, as once I upload the compiled Marlin, the Reprap host software has no effect upon motors, heater, etc. Anyone have a suggestion?
Re: Help compiling Marlin 1.0
March 29, 2012 12:02PM
What Baud rate are you running?
Marlin V1 defaults for 250000, you need to have that speed also set on the host software.

Try Pronterface, I'm not sure RepRap host will support that speed.

Sorry, only registered users may post in this forum.

Click here to login